AA/AAA Battery Charger

Product Introduction:

AA/AAA Battery Charger is provided by Shenzhen Mingke Electronics And Plastics Factory,a major Telecommunication Products supplier in Telecommunication Products wholesale industry in China.You can check out the specification of AA/AAA Battery Charger below or get any optional result clicking into the following keywords AA/AAA Battery Charger and you can check the authentications and testimonials of AA/AAA Battery Charger .

Description:
Specifications:
1) To adopt advanced exactitude switch power supply, worldwide input
voltage: AC100-240V
2) Little heat, save energy source, pollution free
3) Separate wire and charger
4) Streamline structure, small bulk (68 x 110 x 30mm)
5) Smart and easy to carry
6) Apply to charge 4pcs rechargeable batteries at same time or
charging by individual, allowing to charging different category
and capability of batteries
7) Through testing the voltage of each battery with minus
voltage increment control mode ( Less than 10mV) and temperature
to judge batteries are full charged or not
8) With intellectualized MCU control to test batteries application
when they are placed in the socket
9) Max charging current: L2A±10％
10) Trickle current: 50mA±10％
11) Max voltage of battery: 1.8V
12) Highest temperature of battery: 55^oC±3^oC
13) Max charging time:
a) Charge1pc battery: 90minutes; 1800mAh
b) Charge 2pcs batteries: 150 minutes; 1800mAh
c) Charge 3pcs batteries: 225 minutes; 1800mAh
d) Charge 4pcs batteries: 300 minutes; 1800mAh
14) It will be judged battery short-circuit and start protection if
the voltage below 0.1V at any time
15) Defective battery will be inspected in 20 seconds charging time.
If the voltage can't up to 0.8V or over 1.8V, it will be judged
non-chargeable battery and stop charging, then indicates
troubleshooting
16) Indicator:
a) Green LED will light up which indicates power on
b) Red LED will light up which indicates charging is in processing
c) Flashing: 1Hz, green LED will light up which indicates charging
is completed
d) Flashing: 1Hz, red LED will light up which indicates non-applicable
battery
e) Flashing: 1Hz, green LED will light up which indicates temperature
ascend to 55 and start protection function
17) Applicable to digital cameras, toys, MP3, recorders
18) Dimensions: 106 x 65 x 32mm
19) Weight: 180g
20) Operating temperature: -10^oC±40^oC
21) Operating relative humidity: ≤85％
22) Operating atmosphere pressure: 86-106Kpa
23) Storage temperature:-40^oC±60^oC
24) Storage relative humidity: ≤90％
25) Insulation resistor: under the normal atmosphere condition,
insulation resistor of product no less than 10Mohm, the loop of
product can stand 50Hz, 3750V, 1min dielectric strength and no
rupture


Outer packing:
Clamshell
60pcs/ carton
Carton size: 50 x 50 x 60cm
G.W.: 12.5kg