Product Introduction:
Cable is provided by Techwin (China) Industry Co., Ltd,a major Telecom batteries/packs supplier in Telecommunication Products wholesale industry in China.You can check out the specification of Cable below or get any optional result clicking into the following keywords and you can check the authentications and testimonials of Cable .
Description:
The Wirelink (CWL) and Wirevise (CWV) can fasten H-T wires without a toolMerely insert the wires into the holes. The wires are gripped by spring-loaded clamps which tighten more securely as the wires are pulled harder, holding the wires at over 80% of the breaking strength of the wire itselfThe Wirelink is double-sided for joining two ends of wire on in-line splices whereas the Wirevise is half of a Wirelink and is used for terminations at an end post. Each wire on a fence requires one WireviseTo use the Wirevise, drill a 3/8-inch hole through the end post and pull the wire through the hole. Then put the Wirevise on the wire and tap it lightly into the hole. If final tensioning is to be done with the Wirevise, it is recommended to pull the wire to the end post with a chain grab, then push the slack through the hole and Wirevise. A special tightening tool (TVT) is also available for use with the Wirevise. It grabs the wire which has been threaded into the Wirevise and a simple prying action pulls the wire through the Wirevise to the desired tensionA TWR wire release tool can be used to remove most 12.5 gauge Wirelinks from the fence wire This allows the wirelink to be reused if care is taken during both initial installation and later removalCatalog Number Wire range(mm) Tensile strength(lbs/kg)Wirevise-L5056 2.0 to 2.5 1,148lbs/520kgWirevise-L5058 2.6 to 2.9 1,545lbs/700kgWirevise-L5062 3.0 to 3.5 2,250lbs/1020kgWirevise-L5064 3.6 to 4.0 3,240lbs/1470kg
Laser Source |
Pon Optical Power Meter |
Cable Fault Locator |
Optical Talk Set |
Temporary Fiber Aligner |
Handhold Optical Power Meter |